Product Description; Description Of The Control Panel - Concept RK 4060 Manual Del Usuario

PRODUCT DESCRIPTION

1 Lid
2 Kettle body
3 Water mark
4 Button to open the lid
5 Handle
6 Supply cable base
7 Tea strainer (RK4061 only)
C AUTION
Prior to first use, we recommend boiling the maximum volume of water in the kettle at least 3 times, then
pouring it out. The kettle is then ready for operation.
The kettle may only be used with the supplied base.
If any of the buttons is pressed or the kettle is put on the stand connected to the mains, a conforming sound
signal occurs.
OPERATING INSTRUCTIONS
1. Remove the kettle from the base (6), press the button for opening the lid (4), open the lid (1), and fill the
appliance with cold water within the permitted maximum only. If the water level in the kettle is under
the recommended minimum, the kettle will keep overheating and turning off prematurely.
Note: Make sure that the lid (1) is closed properly, otherwise the kettle can not turn off automatically
2. Place the kettle on the base (6); electric contacts will get connected automatically. Thanks to the central
connector design, the kettle can turn around 360° and be put on the base from any side.
3. Connect the base to the mains.
4. Turn the kettle on by pressing the switch ON/OFF (7).
5. The kettle automatically boils water at 10After reaching the boiling point, you hear an audible signal and
the kettle switches off automatically. By pressing the ON/OFF button you can stop the heating process
early.
RK 4060 | RK 4061
1
4
5
2
7
3
8
6

DESCRIPTION OF THE CONTROL PANEL

8 Buton ON/OFF
9 Temperature setting buttons +/-
EN
9
25