Measuring Counter Operation - Advance B562HD Manual De Operación Y Piezas

MEASURING COUNTER OPERATION

Counter base is attached to the guide stay shaft and measuring counter is placed on the pasted mate-
rial reversed by the reverse feed roller. Pull out the pasted material until the cut line (Fig. 7) and lift the
red reset lever of the measuring counter, and it will show "0000." Then pull out the material to paste, as
you are reading the numbers on the counter. You can read the length of the pasted material in "Inches."
Fig. 7
measuring counter
guide stay shaft
cut line
counter wheel
material
Measuring Counter No. 51114
PAGE 9