Rotwerk RB 13 Instrucciones De Uso página 19

from rotating parts.
Do not reach into rotating parts dur-
ing operation. Once shut down, the
device still continues to run for a
short time.
Wear suitable workwear! Do not wear
loose-fitting clothing or jewellery.
Never grasp into rotating workpieces
or machine parts and make sure that
articles of clothing and jewellery can-
not be caught in rotating parts. You
risk being injured!
• warning! sharp chips!
Never remove chips with your bare
hands. You risk being injured. To re-
move chips use a suitable collector.
With the machine switched off, re-
move chips using a brush.
• Do not overload the machine!
It will work more efficiently and more
safely within its specified capac-
ity range. Do not use the machine or
the tools for purposes for which they
were not intended.
• secure the tool and the workpiece!
Make sure the tool and the workpiece
are firmly clamped in place and se-
cured.
• Avoid abnormal body postures!
Make sure you are standing steady
and keep your balance at all times.
• take care!
Pay attention to what you are doing.
Use common sense. Do not use the
machine if you are lacking concentra-
tion or tired. Working on the machine
is prohibited especially if you are un-
der the influence of alcohol, drugs or
medication!
• unplug the plug from the wall
socket!
In the event of faults, when the ma-
chine is not in use, prior to servicing
and when changing tools, always
switch the machine off and pull the
mains plug.
• Do not leave tool keys inserted!
Before switching on the machine,
check that keys and adjusters have
been removed.
• use only original parts!
You may risk injury by using acces-
sories or ancillary equipment other
than recommended in the Technical
Manual.
Electrical safety
Caution: Accidents and injury due to
electric shock can be avoided as fol-
lows:
• Pay attention to the correct mains
voltage!
Make sure the mains voltage matches
the specifications on the rating plate.
• use a socket outlet with a ground­
ing contact!
The machine may only be operated
from a socket outlet with a properly
installed grounding contact.
• Extension cable
The litz wire cross-section of an ex-
tension cable must be at least 1.0
mm
. Always reel out a cable drum
2
fully before using it. Check the cable
for damage.
• Protection against electric shock
Avoid body contact with grounded
components (such as pipes, heating
radiators, cookers, refrigerators).
• Danger from electrical energy!
GB DE
19