Teldy VIOTENNE 55 Instrucciones De Montaje página 3

To install the outside unit proceed as follows:
Install the retaining bracket on the rotating prism
Insert screw 6 through the slot in the rotating prism 5 so that the thread points away
>
from the rotating prism.
Insert retaining bar 7 into screw 6 as shown in the illustration.
>
In each case insert one flat washer 12 onto the two threaded ends of the screw 6
>
and screw on a nut 14, turning it several times.
Install the rotating prism on the reflector support
Insert the rotating prism 5 onto reflector support 2 so that the hole in the rotating prism 5
>
and the top hole in the reflector support 2 are positioned on top of each other.
Insert a screw 11 through a flat washer 12 and into the hole of the rotating prism 5.
>
On the other side, place a flat washer 12 onto the screw 11, put a nut 14 onto the
>
threads and hand tighten.
Turn the rotating prism 5 so that its lower corner is pointing at the elevation angle EL,
>
corresponding to your location.
Insert a second screw 11 through the flat washer 13 and into the hole in the reflector
>
support 2 beneath the rotating prism 5.
On the other side, place a flat washer 13 onto the screw 11, put a nut 14 onto the
>
threads and gently tighten.
Install the swivelling prism on the reflector support
Hold the reflector 1 in front of reflector support 2, as shown in the illustration.
>
Insert one nut 14 into each of the holes provided on reflector support 2.
>
Now connect up the reflector 1 and reflector support 2 to each other using the 4
>
screws 8.
Fitting the LNB arm onto the reflector support
Insert LNB arm 3 into the opening on the front of reflector support 2 and push it in
>
fully, so that it is free of play as it sits in the opening.
If necessary, tap LNB arm 3 gently from the front. If you do so, please ensure that
you do not bend LNB arm 3.
Insert screw 10 through the hole and screw it into a nut 14.
>
Fitting the LNB onto the LNB arm
Separate the two parts of the LNB holder 4 from each other and remove the two
>
connecting bond bridges.
Hook the two parts of LNB holder 4 up to each other on the top side.
>
Place the LNB into the opening of LNB holder 4 (the LNB connections must be
>
pointing downwards at the back) and fold them together.
Insert a nut 14 into the LNB holder and screw these together using screw 9.
>
Now insert LNB holder 4 onto LNB arm 3 and ensure that the former hooks into
>
LNB arm 3.
3