NORTH STATES 4950 Manual Del Usario página 5

8. Remove the template and mount the upper
latch (P/N 4) and upper latch housing (P/N 5) as
shown in figure 8.
Note that one side of the upper latch housing is
higher than the other. This is the gate stop.
The gate stop should be on the side to which
you do not want the gate to open.
If installing the gate by a staircase, the gate
stop must be oriented toward the stairs to
prevent the gate from opening over the stairs!
9. Insert the upper latch (P/N 4) in the recess in
the upper latch housing (P/N 5) as in figure 9.
Secure both parts to the wall with mounting
screws (P/N 14).
Mounting lower latch/latch housing
10. As in step 8, mount the lower latch (P/N 6)
and upper latch housing (P/N 7) as shown in
figure 10a.
Note that one side of the lower latch
housing is higher than the other. This is the
gate stop. The gate stop should be on the
side to which you do not want the gate to
open.
If installing the gate by a staircase, the gate
stop must be oriented toward the stairs to
prevent the gate from opening over the
stairs!
Secure both parts to the wall with mounting
screws (P/N 14) as shown in figure 10b.
Page 5
Note
raised
edge