NORTH STATES 4950 Manual Del Usario página 6

Installing the gate
11. Place the upper and lower hinge spindles (see
figures 11 and 12) on the upper and lower
hinges as shown.
Openings between 1.3" and 2.8" ( 33 mm- 72
mm) should exist between the outer gate bars
and the mounting surface. (See figure 13)
12. Turn lower spindle (figure 12) so that it fits on
the lower hinge.
13. Place the gate in the opening so that the
distance A ( hinge side ) is min. 1.3" (33 mm)
and max. 2.8" (72 mm). The distance B (latch
side) is min. 1.2"(30mm) and max. 2.8"(72mm).
Finalizing gate width setting
14. Adjust the protrusion of the hinge side and latch
side spindles by turning them(se figure 14a) so
that the space requir ement s defined in step 13
are met . . The upper and lower latch spindles
must engage the latches as shown in figure 14b.
e
A
Min 1.3 (3 3 mm)
Max 2.8 (7 2 mm)
Page 6
B
Min 1.2 (3 0 mm)
Max 2.8 (7 2 mm)