Operation - Dimplex CS33116A Manual Del Propietário

Operation

Figure 1
A
B
A. 3-Position Switch
The switch has two On positions
marked with " " and "MANUAL".
The "MANUAL" position is for
manual operation. In this position
the built-in remote control is by-
passed.
The " " position is for operating
the unit with the provided remote
control. When in this position
the unit is operated with the ON
and OFF buttons of the remote
control.
When the switch is in the center
" O " position the unit is off.
B. Heater On/Off Switch
The Heater On/Off Switch
supplies power to the heater
8
fan and the heater element.
When the switch is in the on " I "
position the heater operates if the
thermostat calls for heat.
C. Heater Thermostat Control
C
To adjust the temperature to
your individual requirements,
turn the thermostat control
clockwise all the way to turn
on the heater. When the room
reaches the desired temperature,
turn the thermostat knob counter
clockwise until you hear a click.
Leave in this position to maintain
the room temperature at this
setting. For additional heat, turn
clockwise until you hear the click
again and the heater will turn on.
!
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
heater off and it will not come
back on without being reset. It
can be reset by switching the
NOTE: When the heater
is switched on, the heater
fan will operate. The heater
element may or may not be on
depending on the thermostat
control setting (see "Heater
Thermostat Control").
www.dimplex.com