Parts Description; Bench Mounting - Makita DLS600 Manual De Instrucciones

9. Do not use a damaged battery.
10. The contained lithium-ion batteries are subject
to the Dangerous Goods Legislation
requirements.
For commercial transports e.g. by third parties,
forwarding agents, special requirement on
packaging and labeling must be observed. For
preparation of the item being shipped, consulting
an expert for hazardous material is required.
Please also observe possibly more detailed
national regulations.

PARTS DESCRIPTION

►
Fig.2
1 Lock-off button
5 Blade
9 Base
13 Dust bag
►
Fig.3
16 Lamp
20 Lever (for bevel angle
adjustment)
24 Laser switch
INSTALLATION

Bench mounting

WARNING:
Ensure that the tool does not
move on the supporting surface. Movement of the
miter saw on the supporting surface while cutting may
result in
and
1. Fix the base to a level and stable surface,
screwing with two bolts. This helps to prevent from
tipping and possible
Tape or mask off open contacts and pack up the
battery in such a manner that it cannot move
around in the packaging.
11. Follow your local regulations relating to
disposal of battery.
SAVE THESE INSTRUCTIONS.
2 Switch trigger
6 Blade guard
10 Turn base
14 Dust nozzle
17 Battery cartridge
21 Kerf board
-
loss of
serious personal
injury. ►
Fig.4: 1. Bolt
CAUTION:
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing
void the Makita warranty for the Makita tool and
charger.
Tips for maintaining maximum
4. Charge the battery cartridge if you do not use
it for a long period (more than six months).
3 Handle
7 Sub-fence
11 Guide fence
15 Center cover
18 Hex wrench
22 Lower
- -
control
injury.
battery life
1. Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.
2. Never recharge a fully charged battery
cartridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room
temperature at 10 °C - 40 °C (50 °F - 104 °F). Let
21 ENGLISH
Only use genuine Makita batteries.
fires, personal
damage. It
4 Blade case
8 Small sub-fence
12 Vertical vice
-
19 Release lever
limit 23 Lamp switch
adjusting
bolt
- -
injury and
will also
-
-