Gas Connection - IO Mabe IO6004I PM02 Manual De Instrucciones

8
instructions for installation:
Below we give the instructions for qualified installers so that the
installation,setting and maintenance operations are performed
correctly and according to the regulations in force.
positioning
This appliance isn't connected to any scavenging devices of combustion
products. The appliance can only be installed and operate in
permanently ventilated rooms according to the local regulations in
force. The natural flow of air must be direct through permanent holes
made in the walls of the room to be ventilated leading to the outside,
or through single or collective branched ventilation ducts.
The ventilation openings must have a effective cross-section of at least
100 cm and must be protected against accidental blocking (protection
2
with metal grills or grids). For appliances without safety valve on the
hob, the opening section is doubled with a minimum of 200 cm .
2
There may also be an indirect flow of air from rooms next to that where
the appliance is installed, as long as these rooms have direct ventilation,
there is no fire risk in these rooms and they are not bedrooms. The
flow of air between adjacent room and the room where it is installed
must be free through permanent openings (which may be obtained by
making the gap between door and floor larger). In the room where it
is installed there must be a system for leading the combustion fumes to
the outside. This may be with a hood or an electric fan which switches
on when the appliance is switched on.

gas connection

The appliance must be connected to the gas supply or the cylinder
according to the specifications of the standards in force and after
checking that it is adjusted for the type of gas available.
The appliance is set up to operate with the gas specified on the
calibration label placed both on the packaging and on the back of
the appliance.
When the type of gas available does not correspond to that for which
the appliance is set up, replace the corresponding injectors (provided),
being careful to put on the new calibration label (provided) and
remove the old one.