Bimar VT355 Folleto De Instrucciones página 14

ASSEMBLY
Note: before assembling the fan, ensure that it is not plugged into the
mains.
The appliance can only be used if all parts are completely and properly
assembled, i.e. complete with base, protective grids, rotor.
Proceed as follows, referring to the figures.
1. Insert the power cord through the larger hole
in the base, ensuring that it does not get
pinched.
2. Attach the base, aligning the bigger hole with
the base stand: check that they match up
correctly and secure the parts with the screws,
tightening them with a normal manual force
(excessive tightening with cause the screw to
continue turning, whereas the parts will not
remain secured if not tightened enough).
3. Unscrew the ring nuts (12) and (3) from the motor head.
4. Insert the rear grid (4) onto the motor head so that the handle is at
the back and lock it with the special ring nut (3).
5. Place the fan (10) on the motor shaft (5) and secure with the ring nut
(12) provided screwing it counter-clockwise so as to tighten it.
6. To secure the front grid, place the main unit on a smooth and even
surface. Line up the front grid (1) with the rear grid (4), locking them
with a plastic ring, (it is best to keep the screw at the bottom) and
tighten the screw (11). Thereafter, check that the protective grids are
firmly secured to the motor.
14