Warnings - Jacuzzi J-Sha MI Uso Y Mantenimiento

I
SUCTION INTAKE
• Remove the screw and the cover (the latter has a washer on
the back as shown in the figure ).
• Clean the inlet compartment with a strong jet, using liquid
soap; make sure to clean the flap seal and the valve at the
bottom.
• Then replace the cover, making sure that the washer fits well
into place, on the back of the cover.
I
Any supplementary maintenance operations (electro-mechan-
ical parts and/or electronic components under the tub rim,
scratches or marks on acrylic parts, etc.) are the exclusive re-
sponsibility of qualified personnel; in this case, only contact Au-
thorized Jacuzzi ® Service Centres.
I
For all maintenance and/or repair operations that require the
replacement of components, original Jacuzzi
be used. Failure to comply with this regulation while carrying
out this operation will mean that the Manufacturer is not liable
for any damage that may occur.
Jacuzzi Europe SpA recommends that you contact your local
Jacuzzi ® Service Centre for all operations and intervention not
covered in this manual.

Warnings

I
"JSha Mi" tubs are not playthings. Never leave children
unattended in the tub, especially during the hydromas-
sage function.
I
"JSha Mi" tubs must only be used indoors, for domes-
tic or similar purposes.
I
It is dangerous for a person inside the tub to use de-
vices connected to the electrical network: no electrical
devices must be accessible from the tub.
I
Do not use the water at temperatures over 40°C.
I
Be careful when using the hydromassage when you are
alone. Being in hot water for long periods may cause nau-
sea, dizziness and fainting. If you plan on using the hy-
dromassage for rather long periods, make sure the water
temperature is reasonably low (see the chapter that con-
tains suggestions for preliminary operations).
I
Do not use the appliance after taking alcohol, drugs or
medicines that may cause sleepiness or that may raise/low-
er your blood pressure.
I
While using the hydromassage, keep your head at a dis-
tance of at least 40 cm from the suction inlet; long hair
should be tied up.
Do not start up the hydromassage cycle if the suction
inlet cover is not in position.
Do not point hydromassage jets towards the suction inlet.
I
Do not position watches or any electronic appliances near the
support used for recharging the remote control.
Do not place metal objects on the support used for recharging.
Do not try to open or tamper with the remote control.
I
NB.: When the tub is powered up, you will need to wait 5-10
® spare parts must seconds before using the various functions, so that the comput-
er can carry out initialization tests.
I
We recommend that you fill the tub with water that is already
mixed, to a maximum temperature of 60 °C (that is, do not fill with
boiling water and then cold water), to prevent damage to hosing
and to reduce scale deposits.
I
After using the tub and tap fixtures, make sure the spout lever
is down. That way if the water is inadvertently turned on, water
will come out of the tap and not the shower head.
I
emptying the tub; after use also turn off the section switch in-
stalled on the tub power supply line (see chapter on electrical
safety in the installation manual).
113
Always REMEMBER to turn off the hydromassage before