Metra Electronics INST-4544 Instrucciones De Uso Y De Instalacion página 10

Chevrolet Astro/GMC
Safari 1985-1989
1. Remove (3) Phillips screws from the top portion of
the dash trim bezel. (Figure A)
2. Open the glove box and remove (2) 10mm bolts
from the lower edge of the trim bezel. (Figure A)
3. Pull the console trim forward and remove (2) 7mm
bolts exposed.
4. Gently unclip and remove the trim bezel. Remove
(2) 7mm screws from the factory radio and
disconnect the wiring.
5. Cut and remove all mounting tabs on Bracket #3
EXCEPT tabs "A". (Figure A)
Note: Identify mounting tabs by the stamped letter
on the back of each tab.
Continue to kit assembly
"A"
(Figure A) (Figure B)
Dash Disassembly 99-4544
Chevrolet Astro/GMC
Safari 1990-1995
1. Remove (2) screws from the bottom of the dash
trim bezel. (Figure A)
2. Gently unclip and remove the bezel.
3. Remove (4) screws from the factory radio and
disconnect the wiring.
4. Cut and remove all mounting tabs on Bracket #1
EXCEPT tabs "A". (Figure B)
Note: Identify mounting tabs by the stamped letter
on the back of each tab.
Continue to kit assembly
"A"
(Figure A)
"A"
(Figure B)
10
Chevrolet Astro/GMC
Safari 1996-2004
1. Place the gear selector in its lowest position.
2. Unclip the perimeter of the dash trim bezel.
(Figure A)
3. Disconnect the rear A/C control harness and the
headlight switch from the back of the dash trim
bezel and remove the bezel.
4. Using a flat-blade screwdriver, press down on the
outside clips of the factory radio and remove.
5. Locate Bracket Set #8. (Figure B)
Continue to kit assembly
(Figure A) (Figure B)