Metra Electronics INST-4544 Instrucciones De Uso Y De Instalacion página 18

Chevrolet Lumina APV/
Oldsmobile Silhouette/
Pontiac TransSport
1990-1995
1. Remove (2) screws securing the lower steering
column panel and remove.
2. Remove (2) screws exposed on the left tab of the
radio trim bezel. (Figure A)
3. Open the glove box and remove (2) screws
exposed on the right tabs of the radio trim bezel.
4. Cut and remove all mounting tabs on Bracket #6
EXCEPT tabs "B". (Figure B)
Note: Identify mounting tabs by the stamped letter
on the back of each tab.
Continue to kit assembly
(Figure A) (Figure B)
Dash Disassembly 99-4544
Oldsmobile Silhouette/Pontiac
1. Remove (1) Phillips screw from each side of the center console.
2. Open the glove box and remove (2) Phillips screws exposed.
(Figure A)
3. Remove (2) 7mm hex-head screws and (1) pop-clip from the
lower steering column panel, and (2) Phillips screws exposed
near the climate controls.
4. Remove (1) 7mm hex-head screw under the glove box.
5. Pull out on the center console and remove.
6. Cut and remove all mounting tabs on Bracket #6 EXCEPT tabs
"B". (Figure B)
Note: Identify mounting tabs by the stamped letter on the
back of each tab.
Continue to kit assembly
"B"
"B"
(Figure A)
Chevrolet Lumina APV/
TransSport 1996
(Figure B)
18
Chevrolet Malibu
1. Unclip the radio trim bezel
and remove.
2. Remove (2) 9/32" hex-head
screws securing the factory radio
and disconnect the wiring.
(Figure A)
3. Locate Bracket Set #10. (Figure B)
Continue to kit assembly
(Figure A)
"B"
"B"
(Figure B)
1997-2000