LaserLiner BBQ-GasCheck Manual Del Usario página 6

The device is ready for use immediately once
!
the batteries have been inserted. It does not
have a separate ON/OFF switch and is therefore
always active.
Notes on measurement
– Depending on the propane/butane mix ratio and the
temperature, steel and aluminium gas cylinders are normally
filled up to 80%.
– The measuring device is not suitable for use on plastic
gas bottles.
– The measurement can be adversely affected by dirt on
the measuring head and gas cylinder. The measuring
surfaces should therefore be cleaned with a damp cloth.
– Possible influencing factors on gas cylinders include:
1. Rust (also invisible areas on the inside)
2. Uneven/excessively thick coating on the outer wall
3. Ice build-up on the surface
4. Dented or scratches surfaces
5. Radii of upper and lower ends of gas cylinders too small
To avoid these factors, the measurement should be carried
out at several points in the cleaned central area of the gas
cylinder.
– To avoid sloping liquid levels, the gas cylinder should be
as upright as possible during the measurement.
– To determine the level as fast as possible it is recommended
to start the measurement from the bottom.
– The exact level is at the point between the signals „Gas"
and „No Gas".
– Measurement is not possible on welded seams.
– To avoid damage, do not push the measuring head
over the surface.
2
To measure the level
90°
FULL
SCAN
EMPTY
Place the measuring head vertically on the surface of the
cylinder and press down applying approx. 5 kg of pressure.
A blue LED light sequence signals measurement is in
progress. Hold the scanner steady and pressed against
the cylinder.
A red LED (no level) or a green LED (level found) signals
the finished measurement.
The device switches off automatically if left idle for
2 seconds.
06
EN
BBQ-GasCheck
90° 90°