Section 10: Specifications; Mandatory Disclosures; Performancespecifications; Labels And Markings - Falltech Contractor SRL Serie Manual De Instrucciones

1. Always wear gloves when handling the cable element of the SRL.
2. Using a damp rag and a mild soap and water solution, wipe down the SRL housing
to remove soil and surface contaminants. Ensure that the labels are legible at all
times.
3. Use a damp rag and a mild soap and water solution to clean the cable element of
the SRL. Allow it to air dry and then use a rag that is damp with a light machine oil
to condition the cable.
4. Use a damp rag to clean the surfaces of any connecting hardware.
5. If there is an excessive build up of paint, oil, dirt tar or other contaminants that
cannot be removed, remove the SRL from service and have it replaced.
6. Store in a cool, dry location away from direct sunlight and where it will not be
exposed to chemical vapors.
7. This SRL should be hung on a rack or a peg or stored flat on a shelf, stacked no
more than three high.
8. Do not throw the SRL into a pile or a locker or storage box, as this may damage
the housing.
FallTech Contractor SRL's do not require recertification . Provided your SRL passes
inspection, has been maintained and is in serviceable condition, there is no need to send
it in. If your SRL is in need of repair or you are concerned about its condition, return it
to the place of purchase to arrange and inspection and/or repair through an authorized
service center. For further details, contact FallTech.
Section 10: Specifications
This section contains important information regarding the performance and
construction of this product. Pease read and be familiar with this and all information
contained in this instruction manual.
10.1: Mandatory Disclosures
This instruction manual addresses foreseeable hazards, uses and applications. If you
have questions about your application that are not addressed in this document, contact
FallTech for additional guidance.
It is the responsibility of the employer/issuer of this equipment to ensure that it is
used in a manner consistent with these instructions. Failure to do so could result in
series injury or death.
For further reading and additional information, see Section 10.4 for a listing of
relevant standards with which you should be familiar.
10.2: PerformanceSpecifications
727620 – 20' Contractor SRL
Max. Capacity:
Max. Allowable Free‐Fall:
Max. Arrest Force:
Deceleration Distance:
Ultimate Strength:
Weight:
10.3: Labels and Markings
The label shown below must be present on the product and must be legible. If it is
not, remove the product from service.
310 lbs.
2 feet
750 lbs.
36 inches
3,000 lbs.
10 lbs.
16
727630 – 30' Contractor SRL
Max. Capacity:
Max. Allowable Free‐Fall:
Max. Arrest Force:
Deceleration Distance:
Ultimate Strength:
Weight:
727630 – 30' Contractor SRL
Max. Capacity:
Max. Allowable Free‐Fall:
Max. Arrest Force:
Deceleration Distance:
Ultimate Strength:
Weight:
310 lbs.
2 feet
750 lbs.
36 inches
3,000 lbs.
11 lbs.
310 lbs.
2 feet
750 lbs.
36 inches
3,000 lbs.
11 lbs.