Scion xA 2004-2006
1. Pull outward on the (3) climate control knobs and
remove. (Figure A)
2. Remove (2) Phillips screws from behind the outer two
climate knobs. (Figure B)
3. Unsnap and remove the trim pieces on each side of the
climate control/ashtray/pocket assembly. (Figure C)
4. Remove (2) Phillips screws from the bottom of the
climate control/radio trim panel and unsnap and remove
the entire panel. (Figure D)
5. Remove (4) Phillips screws to remove the factory radio.
6. Remove factory brackets from radio. Retain brackets for
use during kit assembly.
Continue to Kit Preparation
DASH DISASSEMBLY
(Figure A)
(Figure B)
(CONT)
(Figure C)
(Figure D)
13
REV. 12/5/2019 INST95-8202