Accessories; Storage; Service And Repair - RIDGID Compact 100-B Manual De Usuario

Accessories

Only the following products have been designed to
function with the Compact 100-B Pressing Tool. Other
accessories suitable for use with other tools may
become hazardous and/or produce bad presses when
used with the Compact 100-B. Use only accessories
listed below.
Compact 100-B Press Tool Accessories
Catalog
No. Description
12683 14.4V Battery Pack (Original Equipment
Replacement Battery 2.6 Ah Ni-MH)
83407 14.4V Battery Pack (Optional 2.0 Ah Ni-Cd
Battery)
83417 115V Charger
84112 230V Charger
16818 Carrying Case (Plastic)
— RIDGID Compact Series Jaw Sets
Fittings:
Refer to Fitting Systems Operator's Manual for a list of
available fittings for specific fitting systems.

Storage

Place the tool and jaws in carrying case. 100-B should be
stored above 32°F (0°C) and below 122°F (50°C). The tool
temperature sensor will not allow the tool to turn on if oil
temperature is not within this temperature range. This
will be indicated by a red blinking LED on the display
panel.
Store the carrying case in a dry, secured,
WARNING
locked area that is out of reach of children and people
unfamiliar with the Compact 100-B Pressing Tool. The tool
is dangerous in the hands of untrained users.
NOTE! Battery performance is severely reduced
when batteries are stored below 32°F (0°C).
For optimal tool performance and battery life
per charge in cold climates, take care to keep
batteries as warm as possible. When battery
temperatures are kept above 32°F (0°C), the
number of press cycles is dramatically im-
proved, especially on larger diameter fittings.
Compact 100-B Pressing Tool
Other suggestions for improving battery perfor-
mance:
• Use the tool to make pressed connections as
• Be sure to fully discharge the battery before
• Follow proper recharging procedures as spelled

Service and Repair

WARNING
Pressing Tool must be performed by a RIDGID Authorized
Service Center. The tool fasteners have been marked to
indicate if service has been performed by unauthorized
individuals. Improper service or repair may lead to exten-
sive property damage, serious injury or death.
For any repairs or maintenance, contact the Ridge Tool
Company, Technical Service Department at (800) 519-
3456 or www.ridgid.com for nearest authorized service
outlet.
If you have any questions regarding the service or repair
of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: TechServices@ridgid.com
For name and address of your nearest Independent
Authorized Service Center, contact the Ridge Tool Com-
pany at (800) 519-3456 or http://www.ridgid.com
Ridge Tool Company
soon as possible after transferring the battery
from a warm storage environment to a freezing
or subfreezing operating environment. Planning
ahead in this manner will significantly improve
the number of connections achieved before
battery requires recharging.
recharging.
out on pages 5-6 of this manual.
Service and repair on this Compact 100-B
9