Publicidad
Idiomas disponibles
Idiomas disponibles
Scrubbing / cleaning the floor
-Heavily soiled surfaces may require the brush
attachments are used initially to loosen any debris.
Otherwise ensure that the white scrubbing pads
are attached (see page 4).
-Use the white scrubbing pads with floor cleaner or
Ewbank® Floor Polish to remove stubborn stains
or old treatments from the floor surface.
-Turn the product on at the power socket and
select the correct setting selected on the power
button. The default setting is off. Press down and a
light will show on the front of the unit, this means
the polisher is on and the vacuum is off. Press
down again the polisher and vacuum will be on.
-With your foot securing the head of the polisher on
the floor (1), pull the handle towards you (2) and
the product will start (Fig.9). Returning the handle
to its upright position will stop the product.
-Move at a speed of about 1 minute every 10 sq ft
and follow the diagram for an even finish (Fig.10)
-Do not sweep the polisher from side to side.
-Do not leave the product operating in one area
for a prolonged period as this may damage your
floor
-Once cleaning is complete, turn the unit off by
returning it to its upright position. Polishing / buffing
the floor
-Clean floor thoroughly first before adding your
chosen floor polish / wax
-If you are using an alternative floor polishing
wax or oil to Ewbank® Floor Polish, please refer to
the manufacturer's instructions when using with the
Ewbank® 4-in-1 Floor Cleaner, Scrubber Polisher &
Vac
-Start with the blue cleaning pads initially and
buff to a finish with the yellow pads for a
high-sheen finish
-Keep the polisher moving, do not stop in one place
for a long time or it will spoil the finish
-Once polishing is complete, turn the unit off by
returning it to its upright position
-A glossy finish may not always be possible; this
depends on the polish/wax used and the type of
floor surface. Sometimes several coats of polish will
enable a glossy finish.
Fig.9
2.
Pull back
to start
Fig.10
(approx. 1minute per 10 s q ft
Power Cable Storage
-The electrical power cable can be stored on the
rear of the product using the convenient power
cable storage hooks
5
1.
Place foot
on base
3.3ft
3.3ft
)
Publicidad
