Cord, Hose & Accessory Storage - RIDGID 1000RV0 El Manual Del Propietario

SP6962 Pro Pack Plus ESF.qxp_SP6962 6/24/15 1:21 PM Page 7
Assembly
Installing Handle Bracket onto
the Drum
1. Align the the handle bracket assembly
to the back of the dust drum assembly
as shown.
2. Install 5 screws (supplied) through the
matching holes on the back of the
handle bracket assembly into the dust
drum.
3. Tighten screws until just snug.
Do not over tighten as this may
deform or damage the handle bracket
assembly or drum assembly.
Cord, Hose & Accessory Storage
1. Your Vac has convenient locations to
store your power cord, Vac hose, and
accessories.
2. Under the left cover of your Wet/Dry
Vac (as shown) is a storage location
meant to hold your superflex hose,
crevice tool and power cord. For ease
of storage, the hose should be folded
as shown and placed in the storage bin
to the far left. You will also notice a
rectangular feature in the bottom of this
bin. The crevice tool will easily store
standing up in this feature, tapered
side down. Additionally, the power cord
will also fit in this bin to the far right
side. Fold or wrap the cord in
approximately 1-foot lengths until you
get within a foot of the storage bin.
The folded cord should now fit neatly
into the storage bin.
(continued)
Screws (5)
Correct
Hose
Wrap for
Storage
Hose
Storage
Crevice
Tool
Storage
Power Cord
Storage
7
Drum
Handle
Bracket