Lighting Instructions - Pleasant Hearth VFS2-PH20DT Manual Del Usuario

A. This appliance has a pilot which must be lighted by the electronic ignitor. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not
technician to inspect the appliance and to replace any part of the control system and any gas control
which has been under water.
E. Any safety screen or guard removed for servicing an appliance must be replaced prior to operating
the heater.
1. STOP! Read the safety information as noted above.
2. (Select Units) Open the lower access panel located below the
heater screen.
3. Turn control knob clockwise
tion to the left on this label. If you don't smell gas, go to the next step.
5. Turn control knob counterclockwise
Fig. 16). Depress control knob.
6. With control knob depressed, push down on the ignitor button until the
pilot lights. The pilot is located behind the heater screen, centered
near the rear of the burner.
7. Keep control knob depressed for (30) seconds after pilot lights. Release
control knob.
• If the control knob does not pop up when released, stop and immediately
• If pilot goes out repeat steps 3 through 7. Wait (1) minute before attempt-
ing to light pilot again. If after several tries the pilot still goes out, turn the
service technician.
8. Turn control knob counterclockwise
9. (Select units) Close lower access panel.
FOR YOUR SAFETY
READ BEFORE LIGHTING

LIGHTING INSTRUCTIONS

to the "OFF" position (See Fig. 15).
to the "PILOT" position (See
to desired setting.
19
Fig. 15 - Control Knob
NG PILOT
Fig. 16 - Pilot
LP PILOT