O
perations
Wet carpet cleaning
1. attach carpet deep cleaning tool to end
of wand.
2. Place carpet deep cleaning tool directly
on carpet. Pull the spray trigger to spray
cleaning solution while pulling the wand
towards you.
3. Keeping nozzle of the carpet deep
cleaning tool firmly against the carpet
surface, continue to make slow forward
and backward wet passes until no
more dirt can be removed.
Do not overwet.
4. Release spray trigger and make slow
forward and backward passes over
the same area to remove any residual
dirty water.
5. Repeat wet cleaning passes until water
being pulled up appears clean.
6. continue passes without pressing the
spray trigger until you can't see any more
water being pulled up.
7. continue to clean entire carpet working
in 3' by 3' sections.
8. if machine loses suction, stop spraying
and check the collection tank level.
empty if necessary.
9. if the machine stops spraying, turn off
wet clean button immediately and check
the solution tank level.
NOTE: Never run in wet clean
mode when the clean water
formula tank is dry or missing.
w w w . b i s s e l l . c o m
ATTENTION:
some berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area with an ordinary vacuum
or deep cleaner may aggravate
this condition.
8 0 0 . 2 3 7 . 7 6 9 1
11