Polk Audio n1 surroundbar Manual De Instrucciones página 3

19. Replacement Parts. When replacement parts are required,
be sure the service technician has used replacement parts
specified by the manufacturer or that the parts have the
same characteristics as the original part. Unauthorized sub -
stitutions may result in fire, electric shock or other hazards.
CAUTION: Danger of EXPLOSION if battery
is incorrectly replaced. Replace only with the
same or equivalent type. (CR2025)
WARNING: Do not expose batteries or battery pack
to excessive heat such as sunshine, fire or the like.
20. Safety Check. Upon completion of any service or repairs
to this product, ask the service technician to perform
safety checks to determine that the products are in
proper operating condition.
21. Carts and Stands. The appliances should be
used only with a cart or stand that is recom -
mended by the manufacturer. An appliance
and cart combination should be moved with
care. Quick stops, excessive force, and uneven
surfaces may cause the appliance and cart combination
to overturn. Use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
22. This product is not intended for use outdoors.
The CAUTION marks shown here are located on the back
of your SurroundBar Speaker System
®
CAUTION: To prevent electric shock, match wide blade
of plug to wide slot, insert fully.
CAUTION: No naked flame sources, such as candles,
should be placed on the apparatus.
23. Do not install this apparatus in a confined space such as a
book case. Ensure the apparatus has adequate ventila -
tion and that items such as newspaper, table-cloths, and
curtains, etc. do not block the ventilation.
24. WARNING: To reduce the risk of fire or electric shock, do
not expose this apparatus to rain or moisture. The apparatus
shall not be exposed to dripping or splashing. Do not place
objects filled with liquids, such as vases, on the apparatus.
25. WARNING: The mains plug (power adapter) is used as a
disconnect device and shall remain readily operable.
Radiation Exposure Statement
This device complies with FCC radiation exposure limits set
forth for an uncontrolled environment and it also complies
with Part 15 of the FCC RF Rules.
This equipment should be installed and operated with a
minimum distance of 20 centimeters between the radiator
and your body.
Operation
This equipment complies with Part 15 of the FCC Rules
and Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including
interference that may cause undesired operation
of the device.
Polk Customer Service 800-377-7655 (Outside USA & Canada: 410-358-3600)
4
Class B Emissions Limits
This Class B digital apparatus meets all requirements of the
Canadian Interference—Causing Equipment Regulations.
The device meets the exemption from the routine evaluation
limits in section 2.5 of RSS 102 and compliance with RSS-102
RF exposure, users can obtain Canadian information on RF
exposure and compliance.
Product Disposal
Certain international, national and/or local laws and/
or regulations may apply regarding the disposal of this
product. For further detailed information, please con -
tact the retailer where you purchased this product or
the Polk Importer/Distributor in your country. A listing
of Polk Importer/ Distributors can be found on the Polk
website: www.polkaudio.com or by contacting Polk at:
5601 Metro Drive, Baltimore, Maryland 21215, USA.
Phone: 1-410-358-3600; in California: 1-800-377-7655.
NOTE:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy, and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communi -
cations. However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures: reori -
ent or relocate the receiving antenna. Increase the separation
between the equipment and receiver. Connect the equipment
into an outlet on a circuit different from that to which the receiver
is connected. Consult the dealer or an experienced radio/TV
technician for help.
• The antenna(s) used for this transmitter must be installed
to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in con -
junction with any other antenna or transmitter.
• Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.