Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
■ Multi Amplifier with Remote cable connection
(Accessory of KAC-X1D, Optional accessory for XR-1S.)
CAUTION
• Before connecting the remote controller cables, always turn the Bass boost level knob all the way to the left.
You can control the Bass boost level of the second and subsequent Slave amplifiers simultaneously from the
Master amplifier.
The volume level of each amplifier is determined by the setting of the Master amplifier (INPUT SENSITIVITY, boost
level of the remote controller).
Setting the Master amplifier
1. Adjust the INPUT SENSIVITY to the output of the center unit to be connected.
2. Set the LPF frequency and ISF.
3. Turn the LINE OUT FILTER switch ON.
Setting the Slave amplifier
1. Turn the LINE OUT FILTER switch OFF.
2. Adjust the INPUT SENSIVITY.
• To adjust the Slave amplifier to the same volume as the Master amplifier, adjust the INPUT SENSIVITY to 0.2 V
(max.).
CENTER UNIT
(CD receiver, etc.)
Power control wire*
FUSE [30Ax2]
Master amplifier
Extension wire*
FUSE [30Ax2]
Slave amplifier
Hexagon Wrench
(Small)
Use the
attached
FUSE [30Ax2]
Hexagon
Wrench.
Slave amplifier
RCA cable*
BATT.
GND
P.CON
SPEAKER OUTPUT
BATT.
GND
P.CON
SPEAKER OUTPUT
BATT.
GND
P.CON
SPEAKER OUTPUT
* Commercially available parts
Remote cable
REMOTE
LINE IN
LINE OUT
L
R
RCA cable*
REMOTE
LINE IN
LINE OUT
L
R
REMOTE
LINE IN
LINE OUT
L
R
Remote
controller
LINE OUT FILTER
OFF
ON
1
2
0.5
3
0.3
4
5
0.2
[ MIN ]
[ MAX ]
LINE OUT FILTER
OFF
ON
1
2
0.5
3
0.3
4
[ MIN ]
5
0.2
[ MAX ]
LINE OUT FILTER
OFF
ON
1
2
0.5
3
0.3
4
[ MIN ]
5
0.2
[ MAX ]
English
Publicidad
Tabla de contenido
