Braun MultiGroomer MG5090 Manual De Instrucciones página 10

twistable trimmer (4) and press it against the shaver housing until it snaps
into place with a click (e).
3-day beard comb & protective cap (1): This attachment is perfectly suited
for creating a stubble look and maintaining it.
• Place the attachment onto the foil (2) and push up the twistable trimmer (4).
Turn on the shaver and use the appliance as shown in the illustration (e).
The attachment ensures an optimum usage angle.
Adjustable comb (8): This attachment is ideal for beard trimming and keeping
it at a constant length.
• Place the attachment onto the shaver foil (2) and set desired beard length.
Press beard length selector (7) and slide it up (f) (possible length settings
from top to bottom: 1.2 mm / 2.8 mm / 4.4 mm / 6 mm). Push up the
twistable trimmer (4).
• Press the on/off switch and trim against hair growth by guiding the flat
comb part over the skin (f).
Precision comb (9): This attachment is ideal for trimming eyebrows
(ca. 3 mm).
• It is recommended to place the 3-day beard comb & protection cap (1)
onto the shaving foil (2) (e) when using the precision comb.
• Place the attachment onto the extended narrow trimmer (4b) (g).
• Turn on the shaver and trim against hair growth (g).
Cleaning
Regular cleaning ensures better shaving performance. Rinsing the shaver
head after each shave under running water is an easy and fast way to keep
it clean. The hand-held unit should be detached from the power supply cord
before cleaning.
• Switch the shaver on (cordless) and rinse the shaver head under hot
running water (h). You may use liquid soap without abrasive substances.
Rinse off all foam and let the shaver run for a few more seconds.
• Next, switch off the shaver, remove the shaver foil and the cutter block.
Then leave the disassembled shaving parts to dry.
• If you regularly clean the shaver under water, then once a week apply a
drop of light machine oil onto the trimmers (4a, 4b) and shaver foil (i).
Alternatively, you may clean the shaver with a brush (j):
• Switch off the shaver. Remove the shaver foil.
• Using the brush, clean the cutter block and the inner area of the shaver
head. However, do not clean the shaver foil with the brush as this may
damage the foil.
10