Soundoff Signal mpower EMPS2QM Serie Manual Del Usuario página 3

with Clear Duty™ Technology
THREADED
STUD x2
90°±15° EDGE
MOUNT BRACKET
EDGE-MOUNT
1.800.338.7337 / www.soundoffsignal.com
3
®
STUD MOUNT - THREADED LIGHT
HEAT SINK
SETSCREW x2
INSTALLATION:
Edge-Mount Bracket
1. Install Heat Sink onto "mPOWER Stud Mount, Threaded" light
as ndicated. Wire passed through center hole.
2. Install bracket onto "mPOWER Stud Mount, Thread" light as
indicated. Wire passed through rear relief and into lower
edge grip relief.
3. Install 2 lock nuts onto "mPOWER Stud Mount, Thread" light.
Hand tighten until final adjustment.
4. Place bracket over desired vehicle's edge surface (i.e. rear
hood), ensure wire is fully seated in rear relief, wrapping
around edge lying flat.
5. Tighten 2 setscrews to vehicle's edge surface.
6. Adjust angle of light to desired direction and tighten 2 lock
nuts until secure.
7. Make wire connections.
LOCKNUT x 2
mPOWER 9.16