Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
3
Installing the LED strip
There are two installation options to choose from:
3A Tape method: Remove the protective tape from the adhesive back of strip. On a clean and dry surface, place the LED strip (B)
into the desired position and press to ensure proper adhesion to the surface. This method is suitable for indoor applications and
can be used for temporary positioning outdoors in conjunction with method 3B.
3B Clip and screw method: Place the LED strip (B) in the desired position. Use the clips (BB) and screws (AA) to secure the LED
strip (B) as shown. Clips (BB) should be placed in open areas of the strip. Do not cover the LED lights.
NOTE : An additional 18 feet strip may be linked to the original to create a 36 feet strip.
3A
Note :
a.
Angle 90
a. Use an angle greater or equal to 90 degrees when there is an LED chip on the corner
while placing the strip in a concave position. (Angle 90 )
b. Use an angle greater or equal to 60 degrees when there is no LED chip on the corner
while placing the strip in a concave position. (Angle 60 )
c. Use an angle greater or equal to 60 degrees when there is an LED chip on the corner
while placing the strip in a convex position. (Angle 60 ) In the convex position the
angle should not reach 90 degrees. See above diagram.
B
b.
LED Chip
o
o
Angle 60
3B
c.
Correct
lncorrect
lncorrect
7
l P
a e
e s
o c
AA
BB
H
t n
c a
1 t
8 -
7 7
5 -
7 2
0 -
1 3
f 3
r o
u f
O
M
D E
P E
T O
C .
O
M
t r
e h
a r
s s
s i
a t
c n
. e
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
