Front Panel; Rear Panel - Intellinet Network Solutions 561303 Instrucción

English
The Intellinet 8-Port Gigabit Ethernet PoE+ Switch with 2 RJ45 Uplink Ports and LCD Screen offers an array of
time-saving, cost-effective features while providing superior network throughput. No configuration is required
and installation is plug and play. Thanks to its optional desktop and 19" rackmount design, superior performance
and value, the switch is the perfect choice for your small office home or home network. With a backplane speed of
20 Gbps, plenty of performance is available for your computers, servers and other networking devices. Each of the
ports automatically senses the link speed of the connected network device and adjusts to 10, 100 or 1000 Mbps for
compatibility and maximum performance. Designed to give ample power to compatible devices that need them, this
Ultra PoE switch offers up to 30 watts of power per port until its power budget of 130 watts is reached.
Green Ethernet Technology
More often than not, a network switch does not utilize all its ports at all times. Normally, when a computer, notebook,
network printer or other network-connected device is powered down, the switch continues to consume the same
amount of power as if the port were still active. Now, thanks to the new, energy efficient IEEE 802.3az technology, this
Intellinet switch detects link status to all connected devices and reduces the power usage of ports not in use. In
addition, the switch can adjust the level of power output based on the length of the network cable connected to a
particular port. This feature allows for the enjoyment of maximum network performance, and when things slow
down, it automatically scales back power usage to conserve energy and save money.

Front Panel

LED
Power
LNK/ACT
PoE
DIP Switch
• Standard: default mode; allows normal communication between ports 1 – 10.
• VLAN: isolates ports 1 – 8 from each other but can connect to ports 9 or 10; increases the forwarding rate when
broadcast storms occur.
• Extend: allows PoE to be sent over distances up to 250 m (820 ft.); lowers data transmission speeds to 10 Mbps.

Rear Panel

Power
Use the included power cord to connect the device (on the rear panel) to an AC outlet. The device supports AC 100 –
240 V, 50/60 Hz.
Chassis Ground Column
Located on the right side of the power supply connector, the grounding terminal connector is used to provide proper
2
8-Port Gigabit Ethernet PoE+ Switch with 2 RJ45 Uplink Ports and LCD Screen
COLOR STATUS
Off
Green
On
Off
Red On
Flashing
Off
Green On
Flashing
Off
Orange On
Flashing
STATUS DESCRIPTION
Power Off
Power On
No device is connected to the port.
A device is connected to the port at 10/100 Mbps speed.
Sending or receiving data.
No device is connected to the port.
A device is connected to the port at 1000 Mbps speeds.
Sending or receiving data.
No device is connected to the port.
A device is connected to the port.
Abnormal power supply.