Anti-Odor Activated Carbon Filter (For Filtering Hoods); Hood Cleaning; Lighting; Discontinuation - Galvamet VAPORE MINI Instrucciones De Instalación, Uso Y Mantenimiento

water and detergent (or put it in the dishwasher). The filter may become discolored after a few washes. This is normal
and does not mean that it needs to be replaced.
To carry out maintenance on the grease filter, it is essential to remove it from the hood. With the hood turned off, the
condensation collection tray must be opened and the filter removed by its handle (Fig. 6.1.1). At this point, you can
proceed with the filter cleaning. It is recommended to reinsert the grease filter only when it is perfectly dry.
ATTENTION: the grease collected in the filters can easily catch fire and it is therefore extremely
important to clean the metallic filters regularly as per instructions
VI.2 Activated carbon filter (for filtering hoods)
The activated carbon filters, if present, have the function of retaining the odors present in the cooking fumes.
The purified air is recycled into the room. The activated carbon filters must not be washed and must be replaced 3 or 4
times a year depending on the use of the hood. Request the filters to the manufacturer.
To install the activated carbon filters, the metal grease filter must first be removed (Fig. 6.1.1).
At this point, without the use of tools, install the activated carbon filters by hooking them to the interlocking tabs on
motor sides (Fig. 6.2.1). Then fix them by a 90° rotation for their insertion position in the tabs (Fig. 6.2.2). To replace
the activated carbon filters, repeat the described operations backward.
VI.3 Hood Cleaning
The hood must be cleaned immediately after installation and removal of the protective film to eliminate any residual
adhesive or other impurities. The hood must be cleaned frequently both internally and externally (at least once a month).
Do not allow dirt to accumulate on the surfaces of the hood.
Do not use acid or basic products or abrasive sponges to clean the external parts of the hood. Clean the hood with a
sponge moistened with hot water and a small quantity of neutral soap (for example dish soap) to eliminate any grease
particles that may have deposited.
Rinse with a damp cloth, carefully remove all the soap, following the direction of the satin finish of the steel surface.
Drying is particularly important, especially in areas where the water is very hard and leaves limescale deposits.
VI.4 Lighting
The hood is equipped with LED lighting which, in addition to offering excellent lighting and limited energy consumption,
guarantee a considerable duration over time. In case of replacement, contact the assistance service.
VII DISCONTINUATION
The discontinuation means the definitive shutdown and disassembly of the appliance.
After discontinuation, the appliance can be installed on another piece of furniture, privately resold, or disposed of.
Caution! For discontinuation, it is necessary to switch the appliance off and disconnect the power
Disassembly requires that the device is accessible and has been disconnected from the power supply.
To do this, follow the installation instructions in reverse order.
This appliance is marked under the European Directive 2012/19/EC, Waste Electrical and Electronic
Equipment (WEEE).
The symbol on the product or the packaging indicates that the product should not be considered as
normal household waste, but must be taken to the appropriate collection point for the recycling of
electrical and electronic equipment.
The appropriate disposal of this product helps to avoid potential negative consequences for the
environment and health. For more detailed information, contact your local office, local waste disposal
service, or the shop where you purchased the product.
12