Positioning The Machine - WEG LSP Serie Manual Del Usuario

Installation and Connection
Note: It cannot be installed if they are not in the same alignment.
You cannot install out of parallelism.
You cannot install with units inverted (upside down).
Figure 3.2: LSP alignment

3.1.3 Positioning the Machine

To perform the fixation of the LSP, observe the following recommendations.
It should be considered a risk assessment in order to eliminate operator access to the danger zone.
If it is necessary to restrict access from sides or rear of the machine, the installation of others
light curtain or fixed protection grids is recommended, to monitor access to risk zone (See
Figure 3.3 on page 13 and Figure 3.4 on page 13).
12 | LSP