Operation; To Place Or Receive A Call; Programming Numbers Into Memory - Clarity CI000 Guía Del Usario

To Place or Receive a Call:

1. Adjust the Clarity Power Control to its lowest setting (zero).
2. Pick up the handset and listen for the caller's voice or a dial tone. Watch the green
sound level light located on the phone base, next to the program button. It should
sign steady.
3. When placing a call, dial as you would any phone and wait for someone to answer.
4. Press the Boost Button
5. Adjust the Clarity Power Control upwards to a level
where the other party's voice is heard loud and clear, and
begin conversation.
6. When you complete the call, return the handset to the
base unit.
7. After hanging up, the sound level will reset to normal level.
8. Pressing the Boost Button during subsequent conversa-
tions will return the volume to your set sound level.
Note: If you made an error while dialing, just depress the
hookswitch, listen for a dial tone, and dial again.

Programming Numbers into Memory

The Clarity C1000 allows you to program in one help number and ten frequently
dialed numbers into memory for future use. By doing so, you will only have to press
one button to place a call. As a matter of safety, write these important numbers on
the quick reference card under the receiver or below the memory storage locations.
Important: Wait at least two hours after installing for the phone to charge before
you begin programming.
To Program Numbers into the Clarity Phone:
1. Select the number you wish to store for each memory button. The C1000 will let
you store up to 16 digits with each button.
2. Select the correct TONE/PULSE setting you normally dial in. (Remember, some
long distance services require TONE dialing.)
3. Pick up the handset from the phone base, press and release the "PROGRAM"
button on the base unit.
4. Dial the number you wish to store. The number is not transmitted while you are
programming it.
16
TELEPHONE OPERATIONS
help
mute
boost
Help, Mute and
Boost Buttons