Drying Rack; Using The Drying Rack - Maytag NEPTUNE MD68 Guía De Uso Y Cuidado

R
D D
RYING ACK
I D
NSTALLING THE
1) Open dryer door.
2) Position drying rack in tumbler placing the two rear legs
in the two recessed areas in the back wall of the dryer.
3) Place the front lip of the drying rack on top of the lint
filter.
4) Place items to be dried on the rack, leaving space
between them so air can reach all the surfaces.
5) Close the dryer door.
6) Use the Time Dry cycle. Select time according to
moisture and weight of item. Start the dryer. It may be
necessary to reset the timer if a longer drying time is
needed.
U D
SING THE RYING
S I
UGGESTED
Washable sweaters (block to
shape and lay flat on rack)
Stuffed toys (cotton or
polyester fiber filled)
Stuffed toys (foam or
rubber filled)
Foam rubber pillows
Sneakers
S D
TORING THE RYING
On Dryer Sides:
The drying rack hanger fits between the dryer top and the
dryer cabinet.
1) Place the flange on the hanger in the seam between the
top and the cabinet. Push all the way in.
2) Face the top of the drying rack toward the side of the
dryer cabinet.
3) Place the drying rack handle over the lip of the hanger.
On Dryer Back:
1) Place the drying rack hanger between the dryer top and
the dryer cabinet just below the back of the control
panel.
2) Place the flange in the seam and push all the way in.
3) Face the top of the drying rack toward the back of the
dryer cabinet.
4) Place the drying rack handle on the lip of the hanger.
NOTE: If not included with your dryer, contact your Maytag dealer for the accessory kit MAL1100AXX
( )
SELECT MODELS
R
RYING ACK
R
ACK
S
UGGESTED
T . S
EMP ETTINGS
TEMS
Heat
Heat
Air Fluff
Air Fluff
Air Fluff or Heat
R
ACK
or call 1-877-232-6771 USA or 1-800-688-8408 Canada.
Handle
Front
Drying foam rubber, plastic or rubber on a heat setting may
cause damage to the item and could lead to a fire hazard.
10
WARNING
Flange
Lip
Rear Legs