Lega 5409T Manual Del Usuario página 12

19. Take the tab (e) and position it in the appropriate seat on the new pin (c). Apply a small quantity of
copper-based grease.
20. Insert the motor (a) on the central pin, aligning the tab seat, until the pins of the motor support are inserted in
the appropriate slots of the bar, then tighten the screws.
21. If it is present, put the spacer (g) in the hollow shaft of the reducer, adjust the height of the pin that must be
flush with the seat on the reducer with the dowel placed in the nylon bush in the lower area of the vat. Take
the TCBCE screw M6x16 (h) with washer Ø 6 (i) and screw on the head of the new pin (c).
22. Insert the transparent cover (d) on the reducer, tighten the dowels of the bush if present or of the bearing on
the pin and remove the protective film.
www.legaitaly.com - Tel 054626834 – Fax 054628279 – P.iva 00043230390
Costruzioni Apistiche – via Maestri del Lavoro 23 – 48018 Faenza
12 / 38