Publicidad
Idiomas disponibles
Idiomas disponibles
5. Align tabs on gear case cover (HH) with slots in
retaining lip on gear case. NOTE: Position cover
to align locking holes (II) when cover is rotated
counterclockwise.
II
6. Secure cover to gear case with (1) M5 x 12 mm
bolt w/lock washer and flat washer (JJ).
7. Place upper blade fixture (KK) on splined power
output shaft. Blade fixture must engage splines
and fit over outside edge of gear case cover.
8. Place blade (Z) over mounting arbor on blade
fixture (KK).
9. Install blade holder/bolt guard (LL) on output
shaft (MM).
X7502236401
10/17
10. Install the 7x24 mm blade retaining bolt with flat
washer (JJ). Using spark plug wrench/screw-
driver (NN), tighten the bolt firmly in a counter-
clockwise direction. Remove hex wrench.
HH
MM
NN
- 11 -
LL
KK
JJ
Publicidad
