Important - Health O Meter 2210KL Instrucciones Del Usuario

ASSEMBLY INSTRUCTIONS (CONT)
The scale is shipped without the required six (6) C-cell batteries installed. The battery compartment
is located underneath the scale cover. Use the following procedure to install the batteries:
1. Remove the scale top cover by removing the six (6) screws.
IMPORTANT: When setting the cover aside, do not turn or
spin the orientation. The cover only fits properly in one
direction and must be replaced in the same orientation as it
was removed or the tray will not sit properly on the tray
mounting pins.
2. Locate the battery tray (in the rear center of the scale
platform). It has a white cover that is held down with two
screws. Remove the screws and battery cover.
Remove Scale Cover
3. Insert new batteries. Note the orientation that is shown
on the bottom of the battery tray.
4. Replace the battery tray cover and screws. Before installing scale cover, press ON/ZERO to ensure
scale turns on.
5. Reinstall the scale cover. Start partially inserting the (6) screws. Once cover is centered, tighten
screws fully.Ensure the scale cover is replaced in the same orientation that it was removed. The cover
only fits properly in one direction or the tray will not sit properly on the tray mounting pins. To ensure
the cover is placed in the correct direction, the tray mounting pins should be centered in the cover's
four circles.
centered not centered
6. Position the scale with the display buttons facing you.
The acrylic tray has a built-in measuring tape. Align the tray Measuring Tape
so that the measuring tape is positioned over the back end of the
scale platform.
7. Carefully lower the tray onto the four mounting pins on the
scale platform. When the tray is properly aligned with the pins,
gently push down on the tray over each pin until it snaps into its
locked position. When properly positioned, there will be about a
Install Tray
3/8" space between the platform top and the bottom of the tray.
Always lift the scale by the black handles only – never by the tray.
Moving the Scale
The scale should be lifted by the two black handles only.
For your convenience, an optional wheeled cart is available, model # 2210CART.
NOTE: The scale tray should never be used for transporting a baby or objects. The tray
surface must be clear of any objects during transport.
P/N UM2210KL 2210KL4 Rev20190312_Web
7