Maintenance And Cleaning - Global 653577 Instrucciones De Ensamblaje

Ambient temperature is regulated by adjusting the thermostat
dial to a desired position. To select a thermostat setting:
1. Turn the thermostat to the farthest clockwise position.
2. Allow unit to operate and warm the room.
3. When desired temperature is reached, turn control knob
counterclockwise until heater turns off.
4. The heater will start automatically when the room
temperature drops below this set point and will turn off
when set point is reached.
• Adjust the thermostat with each use.
• To turn off the heater, turn the switch to OFF position.
Turn off the circuit breaker. The circuit breaker also
disconnects power to heater.
• This heater includes a visual alarm to warn that parts of
the heater are getting excessively hot. If the Caution LED
flashes, immediately turn the heater OFF and inspect for
any objects, on or adjacent to the heater that may cause
high temperatures. Do not operate the heater with the
alarm flashing. To reset the heater, switch the circuit
breaker OFF, and wait five to ten minutes for the unit to
cool down before turning the heater on.
TROUBLESHOOTING
If your heater fails to operate, please follow these procedures:
This is a wall or ceiling-mounted heater. It has thermal
cut-off protection. If the thermal cut-off protection trips:
Turn off the power. Turn off the circuit breaker. The unit
Problem
Overheat protection has temporarily
deactivated the heater.
Unit is not
Room temperature has reached
heating.
thermostat setting.
Breaker/Fuse has been tripped.
Verify that there are no combustible
materials within 3 feet (0.9 meters)
surrounding the heater.
The heater is
There is oil residue on the heating coil from
producing
the manufacturing process. It will evaporate
a burning smell.
quickly and should not occur again.
Ensure a minimum clearance of 12 inches
(30 cm) from heater to adjacent walls.
PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF.
DOING SO COULD CAUSE DAMAGE OR PERSONAL INJURY.
Multiwatt Heater
Probable Cause
4

MAINTENANCE AND CLEANING

All servicing or maintenance should be performed by
qualified service personnel.
Prior to maintenance be sure to:
1. Disconnect power supply at source.
2. Wait 60 minutes to ensure heating element is cool.
Routine Maintenance:
1. Do not spray or use cleaning liquids or other chemicals
on unit.
2. Interior dust can often be removed with a vacuum
cleaner and crevice tool attachment.
3. To clean enclosure, use a clean, soft and lightly damp
cloth to gently wipe off dirt from surface. Be sure not
to wet heating element or switches. Allow unit to dry
completely before restarting.
CAUTION
Do not allow water to run into the interior
of the heater as this could cause a fire, an
electric shock hazard and damage the unit.
should reset automatically after 10 minutes. If the thermal
cut-off protection trips again, consult a certified electrician
to determine the reason for overheating.
Turn the heater OFF; Switch off the circuit
breaker. Wait 10 minutes before restarting unit.
To increase room temperature, set thermostat
control to higher setting.
Check electrical box to confirm the breaker
is not OFF. This may occur if the receptacle
is shared between other high consumption
appliances. Consult with electrician.
Remove any combustible items near unit.
Ensure heater location is well ventilated.
Reposition heater to increase distance from
adjacent walls.
Assembly Instructions
Solution