How To Assemble Your Ceiling Fan - Fanimation The Landan FPD8087 Serie Manual Del Usuario

How to Assemble Your Ceiling Fan

1. Remove the hanger ball portion from the
downrod/hangerball assembly by loosening the set
screw in the hanger ball until the ball falls freely
down the downrod. Remove the pin from the
downrod, then remove the hanger ball. Retain the
pin and hanger ball for reinstallation in Step 4
(Figure 1).
2. Loosen the two screws in the motor coupler cover
then remove it. Retain the screws and motor coupler
cover for installation in Step 5 (Figure 2).
3. Loosen the two set screws in the downrod support.
Route black and white lead wires through the
downrod (Figure 3).
4. Position downrod support and align the clevis pin
holes in both parts. Install the clevis pin and secure
with the hairpin clip. Tighten the two set screws
and locking nuts in the downrod support (Figure 4).
5. Route wires through motor coupler cover assembly
and tight the two screws from the motor assembly
(Figure 5).
DOWNROD
SET SCREW
DOWNROD
DOWNROD SUPPORT
SCREWDRIVER
5
PIN
HANGER BALL
Figure 1
Figure 2
BLACK AND
WHITE LEADS
DOWNROD
SET SCREWS AND
LOCKING NUTS(2)
Figure 3
SET SCREWS AND
LOCKING NUTS (2)
HAIRPIN CLIP
CLEVIS PIN
Figure 4
Figure 5