BDDMI MODRN HYN-LK2DCB-GY Instrucciones De Ensamble página 6

STEP-BY-STEP ASSEMBLY:
STEP 1:
Carefully tap small wooden dowels into place. Leave 1/2" of the dowels sticking
1
out. Insert H2 into panel C & D. Refer to page 5 on how to use the cam lock system.
Ensure all hardware pieces are properly tightened.
Anti-tip Restraint is REQUIRED in order to complete construction of this product.
When properly installed, this hardware can provide protection against the unexpected
STEP 2:
Make sure the bolts go through the pre-drilled holes properly. Do not over tighten
2
bolts.
finished edge
tipping of furniture.
H7
H9
H8
6/11