Important - Kenmore 183.91579 Guía Del Cuidado/Del Uso

2. Attach the CO regulator to the CO
2
screwing the regulator nut onto the cylinder valve and
tightening with an adjustable wrench.
3. Remove the bolt with the nut from the cylinder retainer.
Using two screws attach it inside the unit on the left side
of the back wall. (Holes are pre-drilled and screws are
included)
4. Slide the cylinder through the retainer and secure it with
the bolt and the nut. Position the cylinder so that you will
be able to read the numbers on the gauge and
easily access the shut-off valve and pressure adjustment
screw.
CO
2
Regulator
Gauge
Pressure
Adjustment
Screw
Clamp
Shut-Off Valve
Connect to the
Keg Tap (coupler)
Retainer
CO can be dangerous! CO
2
which can be hazardous if handled improperly.
They must be handled with care.
Tapping the Beer Keg – Installing Keg Tap
(Single-Valve Type Barrel)
Your beer dispenser comes with American Sankey Tap. This
type is the most widely used in the United States. Before
purchasing a keg, check with your beer distributor to make
sure that supplied Sankey Tap can be used.
Note: For European draft beer, European Sankey Tap is
required. Please contact Draught Technologies by
visiting www.draughttech.com or call
(860) 677-7312.
cylinder by
2
Connect to the CO Cylinder
2
CO2 Cylinder
CO
2
WARNING!
cylinders contain high-pressured gas,
2
Follow the steps below to tap the keg of beer.
1. Make sure the pull handle of the Sankey Tap is in the
closed (up) position before installing it on the beer keg.
(see fig.1) Insert the keg coupler into the locking neck of
the beer keg and turn clockwise 1/4-turn to lock it into
position. (see fig. 2)
fig. 1
Coupling Head
Plastic Insert
Connect to the CO
Gas Line Tube Barb
fig. 2
2. IMPORTANT: You must insert the black rubber washer
into the beer line coupling nut before screwing the nut
onto the keg tap coupling head. First remove the black
protective shipping cap from the coupling head. Do not
remove the plastic insert from the coupling head. Insert
the black washer inside of the coupling nut. Firmly
hand-tighten the coupling nut onto the coupling head.
(see fig. 3)
3. Attach the open end of the red tube to the hose barb
connection on the Sankey Tap. Next, secure the tube by
using the remaining self-locking plastic snap-on clamp
to ensure that there are no leaks. Secure the clamp
tightly with pliers. (see fig. 3)
fig. 3
5
Pull handle (upward)
2
Keg Coupler
Beer Keg Neck
Beer Line
Coupling Nut
Red Tube (gas line)