Mounting The U-Bracket - Tait TM81 Serie Guía Del Usario

Mounting the U-bracket

The U-bracket can be used to install the radio on the dash-
board or on any sufficiently flat surface, using the self-drilling
screws and washers provided in the installation kit.
Caution:
Caution:
1
2
Caution:
3
When mounting the radio, check whether the
mounting surface needs to be reinforced.
The U-bracket must be installed using at least
four screws.
If the U-bracket is being mounted over a curved surface,
bend the U-bracket tabs slightly, to match the
surface shape.
Drill any holes required for cables and install suitable
grommets or bushings in the holes.
Check that the U-bracket is not distorted when the
screws are tightened.
Screw the U-bracket in the
chosen mounting position using
the self-drilling screws and
washers provided.
Tip: For more precise
positioning, predrill
(1/8 inch) pilot holes for the
self-drilling screws. Reduce the hole size in metal that is
less than 1mm (1/32 inch) thick.
3mm
Radio installation 37