Installing The Batteries - Home Decorators Collection KINGSBROOK 51608 Guía De Uso Y Mantenimiento

Operating Your Fan and Remote Control

Installing the batteries

NOTE: The battery will weaken with age and should be replaced
before leaking takes place as this will damage the remote control.
Dispose of used battery properly and keep the battery out of the reach
of children.
NOTE: The remote ships from the factory with the dip switch set to
DIM. The light's dimming capability will be lost if the dip switch is
switched to the ON position.
□
Remove the battery cover by pressing firmly on the arrow
and sliding the cover off.
□
Install two 1.5V AAA batteries (included).
□
Replace the battery cover on the remote control.
Learning process
NOTE: After the AC power is on, do not press any other button on
the remote control before pressing the
Doing so will cause the procedure to fail.
NOTE: The remote control can learn multiple receivers. Make sure
no other receivers are operating during the learning process.
Separate the fan power switches by approximately 2 meters.
Should you desire to use another remote control unit with your
new fan, install one using the steps below:
□
Turn the main power source off to begin the learning process.
□
Return the power to the unit.
□
Within 30 seconds of turning the fan's AC power ON, Press and
hold the button for 5 seconds to enter the learning function.
Once the receiver has detected the set frequency, the down light
of your fan, if applicable, will blink twice. There is no indication if
your fan is not equipped with a light.
(FAN ON/OFF) button.
Comfort Breeze
13
LED bar
Scale indicating
fan speed
TM
Warm weather
(Forward)
Decreases the
light level
(Dimmer)
Please contact 1-800-986-3460 for further assistance.
Fan on/off
Increases fan speed
Decreases fan speed
Timer
Cool weather
(Reverse)
Increases the
light level
(Dimmer)
Light on/off
HOMEDEPOT.COM/HOMEDECORATORS