Juego De Limpieza - Greenway GWD5440W Manual De Uso Y Cuidado

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

perating

nstructiOns

Initial Product Cleaning Procedure

Like most appliances, your water dispenser requires periodic maintenance for

maximum efficiency and performance and must be cleaned on a regular basis

(i.e. every 4 months). To maintain a hygienic environment within your water

dispenser and prevent potential formation (growth) of bacteria, we strongly

recommend regular cleaning. A cleaning kit is available through our Customer

Service Department at 1-866-253-0447 or can be ordered on line

at www.greenwaywt.com.

1. Make sure the unit is unplugged.

2. Remove the bottle support collar, saturate a clean cloth with a Greenway

water dispenser cleaner or vinegar and wipe the inside of the reservoir.

3. Pour the water dispenser cleaner or a mixture of 4 cups / 1 L of vinegar

with 4 cups / 1 L of hot water into the reservoir and wait 20 minutes.

IMPORTANT: To avoid water overflow while cleaning the dispenser, always

remove the bottle support collar before pouring water or cleaning solution

into the reservoir (see Figure A).

4. Press both dispensing buttons until water no longer comes out.

5. Using a bucket, drain the reservoirs from the drain valve on the

back of the unit.

6. Rinse again with clean water, re-install drain valve plug and cover.

7. Place bottle support collar back on top of dispenser.

Installing the Water Bottle

IMPORTANT: Always wash your hands first! Clean the top (neck) of the bottle with a clean cloth and do not touch

the part of the unit that the water touches. Make sure the unit is unplugged. The water bottle can be purchased

from your local retailer.

1. Remove the protective cap from the end of the water bottle unless the bottle has a puncturable

cap or sticker.

2. Lift and turn the bottle upside down, placing it securely on the bottle support collar.

3. Press and hold both dispenser buttons until water flows from the dispenser. Drain about 4 cups / 1 L of water

before initial use. This does not need to be repeated with replacement bottles.

4. Plug in the water dispenser.

5. Ready-to-dispense indicator lights will come on when water reaches optimum temperature and is ready for use. In

order to get steaming hot water, the Kettle Feature needs to be activated (see Dispensing Hot Water).