Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan
Tools Needed for Assembly
One Phillips head screwdriver
One stepladder
One ¼ "blade screwdriver
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 8). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
Motor Assembly—Unpacking Instructions and Parts Identification
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
s
e t
p
s
h
a
v
e
b
e
e
n
c
o
m
p
e l
WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
Ceiling Plate Assembly
Motor Assembly
NOTE: The illustration shown is not to scale or its actual configuration may vary.
Parts and packings subject to change without notice.
9
/
"Socket head wrench
16
One wire stripper
e t
d
a
n
d
w
l l i
b
e
h
l e
f p
l u
n i
MA7966 Motor Assembly and Hardware Parts Identification
Housing Assembly
Wiring outlet box and box connectors must be of type re-
quired by local code. The minimum wire would be a 3-con-
ductor (2-wire with ground) of the following size:
Installed Wire Length
NOTE: Place the parts from the loose parts bags in a
small container to keep them from being lost. If any parts
are missing, contact your local retailer.
n i f
d
n i
g
y
o
r u
p
a l
c
e
s
h
o
u
d l
Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 17)
Ceiling Plate Assembly
Motor Assembly
Rivet Tool
Punch Tool
Belt Clamps
Rivet Tool
Figure 1
4
Materials
Wire Size A.W.G.
Up to 50 ft.
50 - 100 ft.
y
o
u
b
e
i
t n
r e
u r
p
e t
. d
Wood Screw
– Five #10 Type B Flat Washer
– Wire Connectors
Hand-held Remote
Punch Tool
14
12
Hardware bag
Belt Clamps
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
