Whittier Wood Products Taylor 159W Instrucciones Para Armar página 6

N
x 4
FIG. 9
9) Cover your work surface with a cloth or piece of cardboard to protect the finished seat. Place the
seat upside down on the work surface. Be sure the front of the swivel is placed towards the front
of the seat, ("FRONT" is stamped on top of swivel.) Place the leg assembly upside down on the
bottom of the seat and line up the holes in the swivel with the pilot holes in the seat. Screw the
swivel into place through the access holes in the disc using the #14 x 3/4" Pan Head Screws (N).
Turn the leg assembly until the other two sets of holes line up with the access holes in the disc
and finish screwing the swivel down with the #14 x 3/4" Pan Head Screws (N). SEE FIGURE 9.
FIG. 10
10) The legs are Grooved at the bottom to allow them to be cut down to different lengths. The
resulting seat heights are shown in FIGURE 10.
Page 6 — 159W
23½" seat height
25½" seat height
27½" seat height
29½" seat height