Carpet Cleaning; Cleaning After Use - Bissell COMPACT 48X4 Manual De Instrucciones

C-1 Filling formula & water tank
1. Remove tank by lifting it straight up, then
away from lower body.
2. Unscrew black cap located on bottom of
tank.
3. Fill with hot (not boiling) tap water
(140°F/60°C MAX) to WATER line. Fill rest of
tank with BISSELL 2X Formula to FORMULA
line. Replace and tighten black cap.
Caution: Do not microwave or boil water
before filling.
4. Place tank on lower body.
C-2 Carpet cleaning
1. Plug into proper outlet.
2. Adjust retractable handle by turning
counterclockwise and lifting handle up.
Turn clockwise to secure.
3. With foot, press red power pedal,
located on back of machine.
NOTE: Handle must be in the full upright
position before cleaning.
4. With foot, press grey recline pedal located
next to power pedal.
5. While pressing trigger, make one slow
forward wet pass and another one back.
Caution: Do not overwet.
6. Release trigger and make one slow
forward and backward pass over the same
area.
7. Repeat steps 5 and 6 until solution being
pulled up appears clean.
8. Empty dirty tank when dirty water
reaches FULL line, or when formula and
water tank is empty.
C-3 Area rug cleaning
Important! Please check manufacturer's tag
before cleaning area rugs for any specialized
cleaning instructions. We do not recommend
deep cleaning delicate, silk, wool, antique or
area rugs without a manufacturer's tag.
When cleaning area rugs, place rug on a
sealed surface and test a small, inconspicuous
area for colorfastness. Your carpet cleaner
should not be used on unsealed surfaces.
Follow carpet cleaning instruction in section
C-2. Keep foot of cleaner perpendicular to
rug's edge with each cleaning pass to prevent
damage.
C-4 Empty the dirty tank
1. With foot, press the red power pedal to
turn off and unplug power cord from outlet.
2. Remove dirty tank from base of unit.
a. Release dirty tank latches (on each
side) by pulling up from bottom of latch
and then out.
b. Carefully remove tank by lifting up on
the tank handle.
3. Carry dirty tank to a toilet or sink. To
empty, pour out contents using opening at
back of tank.
4. Rinse tank thoroughly and replace on unit.
5. Refill formula & water tank and continue
cleaning.
C-5 Cleaning after use
1. Unplug power cord from outlet.
2. Remove and rinse dirty tank thoroughly.
3. Remove tank vent & foam filter (located
on top of tank) and rinse.
4. Clean nozzle window by lifting latch and
removing nozzle from machine. Rinse under
running water.
5. When finished replace nozzle and secure
with latch.
NOTE: For best results, it is recommended
that the nozzle is cleaned after each use.
6. Remove lint and hair from red gasket in
base of unit. (Do not remove gasket)
7. Replace dirty tank on base of machine and
secure with latches.
ATTENTION
Some Berber carpets have a tendency to fuzz with wear.
Repeated strokes in the same area with an ordinary vacuum
or deep cleaner may aggravate this condition.
www.BISSELL.com
7