First Use And Installation - Hisense RR33D6ABE Manual De Instrucciones

5
State of California Proposition 65 Warnings:
WARNING:This product contains one or more chernicals known to the State of California to
cause cancer.
WARNING:This product contains one or more chernicals known to the State of California to
cause birth defects or other reproductive harm.

First use and Installation

Cleaning before use
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
some neutral soap so as to remove the
typical smell of a brand new product, then
dry thoroughly.
Important! Do not use detergents or
abrasive powders, as these will damage the
finish.
Important! It is necessary to have good
ventilation around the refrigerator to allow for
the dissipation of heat, high efficiency, and
low power consumption.
sufficiently cleared
available around the
advisable for there to be
separating the back of the
the wall at least
100 mm / 4 inches
on its two sides, a height
from its top and a clear space
4 inches
in front to allow the doors to open 180°.
Appliances must not be exposed to rain.
Sufficient air must be allowed to circulate in
the low rear section of the appliance, as
poor air circulation can affect performance.
should be positioned away from
Appliances
heat sources such as heaters and direct
sunlight.
100 mm / 4 inches
100 mm / 4 inches
For this reason,
space should be
refrigerator . It is
75 mm / 3 inches
refrigerator to
of space
of over
100 mm /
75 mm / 3 inches
Installation Positioning
Warning! Before installing, read the
instruction carefully for your safety
and correct operation of the appliance.
This appliance performs well within the
Ambient temperature from 55 deg F /
12.8℃ to 110 deg F / 43.3
It may not work properly if being left at a
temperature above or below the indicated
range for a long period.
Stand your appliance in a dry place to
avoid high mosture.
Keep the appliance out of direct sunlight
rain or frost. Stand the appliance away
from heat sources such as stoves, fires or
heaters.
Installing the rubber anti-tip pad
If there is a rubber anti-tip pad and
a screw provided in a plastic bag with
your appliance ,you must install these
accessories according to the following
procedure.
Note:
There is no need to install these accessories under
normal usage, Only under the extreme circumstance,
cabinet empy while load on door with local mass of
10 kg / 22 pounds and opening the door about 90
degree, this refrigerator may take risk of tipping, Then
anti-tip should be fastened to the lower base cover to
steady this appliance.
1.Tilt appliance to find screw hole on the
left of lower base cover.
lo wer base cover
5
℃.