Brandson Equipment 303584/20190227NB102 Manual Del Usuario página 12

Depth of an object
7. Cleaning and Care
• Always keep the device in a clean and dry place.
• Use only a soft and dry cloth for cleaning. Avoid abrasive cleaners, acetone or
alcohol for cleaning.
• Do not drop the device and avoid contact with liquids. This may impair its
function and damage the device.
• The battery has to be replaced when the slide callipers display starts flashing.
8. Replacing the battery
The display becomes weak when the battery capacity is exhausted. Remove the
battery along with the battery compartment and replace them. When inserting
the new battery ensure the polarity of the contacts is correct. Here, the "+" pole
should face the top (display) and the "-" pole towards the PCB.
9. Safety instructions and disclaimer
Never try to open the device to carry out repairs or modifications. Avoid contact
with the mains voltage. The device is free of current only when it is disconnected.
Do not short-circuit the product. Please disconnect the power cord when not in
use or during storms. The device is not approved for outdoor use. Therefore please
use it only in dry surroundings. Protect it from high humidity, water and snow.
Keep the device away from high temperatures. Do not expose the device to sudden
changes in temperature or strong vibrations, as this could damage the electronic
components. Check the device for any damage before using it. The device should
not be used if it was subject to impact or has been damaged in some other manner.
Please comply with the local regulations and restrictions. Do not use the device
for purposes other than those described in the user manual. This product is not a
12
10.43mm
English