Troubleshooting - Royal Sovereign ARP- 5010X Manual Del Propietário

troubleSHootinG

problem
Air Conditioner does not operate
Air Conditioner runs but does not cool
Air Conditioner does not run
and water full indicator is lit
- Check and reset the power plug. Wait 3 minutes and try to run the unit again.
- The batteries in the remote may need to be replaced. Replace the batteries and try to run the unit again.
- Make sure the plug is properly plugged into the outlet.
- The set temperature may be too close to room temperature. Lower the set temperature.
- The air outlet may be blocked. Check the air outlet and remove any items that may be found.
- Check the room for open doors or windows and close them.
- There may be another appliance in the room giving off heat. Check the room and turn off the appliance.
- The air filter may be dirty. Check the filter and clean if necessary.
-∙The∙air∙exhaust∙or∙intake∙may∙be∙blocked.∙∙
- The set temperature may be too high. Check the set temperature and reduce it if necessary.
-∙There∙may∙be∙excess∙water∙in∙the∙unit.∙Drain∙the∙unit.
13
arp-5010X, 5012X, 5012XH
possible reasons