Auto Channel Scan; Language Selection - TruTech CR270TT8 Manual Del Usuario

• ENG/ESP/FRA
You can change the language (English, Spanish,
French) displayed on the main menu.
(Refer to "Language Selection" on page 11.)
• V-CHIP SET UP
You can set the viewing limitations.
(Refer to "V-chip" on page 20.)
• CAPTION
You can change the display format for closed caption,
which displays the dialogue of a TV program or other
information across the TV screen.
(Refer to "Closed Caption" on page 17.)
• DTV SET UP
You can set the screen display or caption in the DTV
mode.
(Refer to "DTV Closed Caption" on page 18.)

Auto Channel Scan

If you switch wires (e.g., between antenna and CATV) or if you move the TV
to a diff erent area after the initial setting, or if you recover the DTV channel
you deleted, you will need to perform auto channel scan.
Before you begin:
Make sure if the unit is connected to antenna or cable.
1
Press [MENU] to display the main menu.
MENU
2
Use [CH K/L] to select "CHANNEL SET",
then press [VOL X ].
CH
or
CH
VOL
3
Use [CH K/L] to select your desired preset type,
then press [VOL X ].
CH
or
CH
VOL
e.g.) digital TV mode
PICTURE
CHANNEL SET
[ENG]/ESP/FRA
V-CHIP SET UP
CAPTION [OFF]
DTV SET UP
e.g.) digital TV mode
ADD/DELETE(DTV)
AUTO PRESET CH(DTV)
AUTO PRESET CH(TV/DTV)
AUTO PRESET CH(CATV)
! CATV takes approx. 50min.
• When aerial antenna is connected, select "AUTO
PRESET CH (TV)", "AUTO PRESET CH (DTV)" or "AUTO
PRESET CH (TV/DTV)".
• When connected to CATV, select "AUTO PRESET CH
(CATV)".
• Auto scanning begins.
• When the scanning and memorizing are completed,
the lowest memorized channel will be displayed.
• When you selected "AUTO PRESET CH (TV/DTV)", the
lowest memorized analog channel will be displayed
when the scanning and memorizing are completed.
If there is no analog channel, the lowest memorized
digital channel will be displayed.
Note:
• If you connect the cable system directly, contact the CATV
installer.
• If you press [POWER] or [MENU] during "AUTO PRESET CH",
the setting will be canceled.
• When no channel can be received by "AUTO PRESET CH", "NO
TV SIGNALS" is displayed on the TV screen.
• Channel setting will be saved even if the power fails.
• With regard only to the digital channel, even after the
scanning is complete if you unplug the AC power cord before
turning off the unit by pressing [POWER], the channel setting
may be lost.

Language Selection

You can choose English, Spanish, or French as your on-screen language.
1
Press [MENU] to display the main menu.
MENU
2
Use [CH K /L] to select "[ENG]/ESP/FRA",
then press [VOL X] repeatedly to change the setting.
CH
or
CH
VOL
3
Press [MENU] to exit.
MENU
e.g.) digital TV mode
AUTO PRESET CH(DTV)
e.g.) digital TV mode
PICTURE
CHANNEL SET
[ENG]/ESP/FRA
V-CHIP SET UP
CAPTION [OFF]
DTV SET UP
[ENGLISH]
[ESPAÑOL]
[FRANÇAIS]
11
EN