Led Indication - Siemens RCR114.1 Guía Rápida

en
Initiating the connection to the RDS110.R
1. On the Home screen of the RDS110.R, tap
is displayed.
2. Enter the administrator password at the prompt.
3. Tap > , and then Pair new devices.
4. On the receiver (RCR114.1), short press button
5. Perform the above action on all receivers if you have more than one RCR114.1. The LED
flashes green while connection is established and turns to steady green when it succeeds.
Note: One RDS110.R can pair up with max. 6 relays (for heating systems) and max. 3
repeaters (for network extension).

LED indication

Device status
Idle
Connecting to RDS110.R
Successful connection
Thread network works, but communication with
RDS110.R failed
Thread network failure
Factory reset
1) Reconnection is performed automatically or manually.
2) Reconnection can only be performed manually.
Manual network reconnection
1. Check whether RDS110.R is powered on and in normal operation.
2. If the reconnection still fails, delete RCR114.1 in the device list of RDS110.R, then long press
button on RCR114.1 for 8 seconds and re-add RCR114.1 to the device list.
Technical specifications and availability subject to change without notice.
Siemens Switzerland Ltd. declares that the radio equipment type RCR114.1 is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is available at
www.siemens.com/download?A6V10733818.
2 / 26
1)
2)
, then and . The Advanced settings screen
. The LED flashes green.
LED status
Solid orange
Flashing green
Solid green
Flashing red
Solid red
Alternating red and green
A6V11562447_en--_a