Safety Information; General Information; Hygiene; Nuk Breast Milk Container - NUK JOLIE Instrucciones De Operación

Breastfeeding is best for your baby.
For your own safety please observe the
following:

3.1 General information

• Before using the pump, please read
these instructions for use carefully.
These instructions are part of the unit
and must be kept to hand at all times.
• Use the NUK JOLIE Breast Pump and
accessories for their intended purpose
only (see "2.1 Intended use")
• To avoid the risk of choking, keep small
parts that may be swallowed out of the
reach of children.
• We recommend removing any fatty or
oily creams from your breast before
using the pump, as these may damage
the surface of the breast shield.
• To guarantee that the pump will function
correctly, only
accessories.
• Please note that any claim under
warranty or liability will be void if
accessories are used which are not
recommended
instructions, or if any parts other than
original spare parts are used for repairs.
This also applies to repairs carried out
by unqualified persons.
• If in the event of any malfunctions,
please contact manufacturer.
• If the breast milk is for a premature baby,
it is essential to follow your doctor's
instructions.

3.2 Hygiene

• To ensure the healthy development of
your child, when handling breast milk,
hygiene is of the utmost importance.

3. Safety information

use orginal
in these operating
• Remove
piercings) before using the breast pump.
• To prevent
contamination (microbial growth) and to
prevent damage to the pump, please
read and pay attention to "6. Cleaning
and sterilising" on page 17.
• Only a breast pump which has been
thoroughly cleaned will achieve full
suction strength.
3.3 NUK Breast Milk
Container
3.3.1 Preparation
• Do not microwave bottles filled with feed
or water (risk of explosion/material
damage).
• Uneven heating may result in scalding!
• Never heat closed bottles as they may
NUK
explode!
• Before each use, softly squeeze vent
and drinking hole/slit to ensure it is
open.
• Cooling down a PP bottle that has been
filled with hot liquid (> 80°C) and sealed
with the lid afterwards, could cause the
bottle to deform permanently.
3.3.2 Cleaning
• Before first use place in boiling water for
5 minutes, use sufficient water to avoid
damage.
• To ensure hygiene, clean thoroughly
using mild washing up liquid and sterilise
before every further use. We recommend
to use the NUK Steriliser Vapo Rapid for
sterilisation.
• Always dismantle the bottle for boiling or
steam sterilising (temperature above
15
all body jewellery
infection or
(e.g.
bacterial